
W90P710CD/W90P710CDG
- 20 -
5. PIN DESCRIPTION
Table 5.1 W90P710 Pins Description
PIN NAME IO TYPE DESCRIPTION
Clock & Reset
EXTAL (15M) I 15MHz External Clock / Crystal Input
XTAL (15M) O 15MHz Crystal Output
EXTAL32(32.768
K)
I 32768Hz External Clock / Crystal Input(for RTC)
XTAL32(32.768K) O 32768Hz Crystal Output(for RTC)
nRESET IS System Reset, active-low
JTAG Interface
TCK IDS JTAG Test Clock, internal pull-down with 58K ohm
TMS IUS JTAG Test Mode Select, internal pull-up with 70K ohm
TDI IUS JTAG Test Data in, internal pull-up with 70K ohm
TDO O JTAG Test Data out
nTRST IUS JTAG Reset, active-low, internal pull-up with 70K ohm
External Bus Interface
A [21:18] O Address Bus (MSB) of external memory and IO devices.
A [17:0] IOS Address Bus of external memory and IO devices.
D [31:16] /
VD[23:8] /
GPIO [67:52]
IOU
Data Bus (MSB) of external memory and IO device, internal pull-up with 70K
ohm.
General Programmable In/Out Port GPIO[67:52].
D [15:0] / IOU Data Bus (LSB) of external memory and IO device.
nWBE [3:0] /
SDQM [3:0] /
GPIO[69:68]
IOU
Write Byte Enable for specific device (nECS [3:0]).
Data Bus Mask signal for SDRAM (nSCS [1:0]), active-low.
General Programmable In/Out Port [69:68]
nSCS [1:0] O SDRAM chip select for two external banks, active-low.
nSRAS O Row Address Strobe for SDRAM, active-low.
nSCAS O Column Address Strobe for SDRAM, active-low.
nSWE O SDRAM Write Enable, active-low
MCKE O SDRAM Clock Enable, active-high
MCLK O System Master Clock Out, SDRAM clock, output with slew-rate control
nWAIT /
GPIO[70] /
nIRQ5
IOU
External Wait, active-low.
This pin indicates that the external devices need more active cycle during
access operation.
General Programmable In/Out Port GPIO[70]. If memory and IO devices in EBI
do not need wait request, it can be configured as GPIO[7] or nIRQ5
nBTCS O ROM/Flash Chip Select, active-low.
nECS [3:0] O External I/O Chip Select, active-low.
nOE O ROM/Flash, External Memory Output Enable, active-low.
Comentários a estes Manuais