Rainbow-electronics AT90LS4433 Manual do Utilizador descarregar pdf (Página 53)

AT90S/LS4433

1042G–AVR–09/02

UART The AT90S4433 features a full duplex (separate Receive and Transmit Registers) Uni-

versal Asynchronous Receiver and Transmitter (UART). The main features are:

•

Baud Rate Generator Generates any Baud Rate

• High Baud Rates at Low XTAL Frequencies

• 8 or 9 Bits Data

• Noise Filtering

• Overrun Detection

• Framing Error Detection

• False Start Bit Detection

• Three Separate Interrupts on TX Complete, TX Data Register Empty, and RX Complete

• Multi-processor Communication Mode

Data Transmission A block schematic of the UART Transmitter is shown in Figure 40.

Figure 40. UART Transmitter

Data transmission is initiated by writing the data to be transmitted to the UART I/O Data

• A new character has been written to UDR after the stop bit from the previous

character has been shifted out. The Shift Register is loaded immediately.

• A new character has been written to UDR before the stop bit from the previous

character has been shifted out. The Shift Register is loaded when the stop bit of the

character currently being transmitted has been shifted out.

When data is transferred from UDR to the Shift Register, the UDRE (UART Data Regis-

ter Empty) bit in the UART Control and Status Register A, UCSRA, is set. When this bit

is set (one), the UART is ready to receive the next character. At the same time as the

UART CONTROL

AND STAUS

UART CONTROL

AND STAUS

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 124 125

Sem comentários

Rainbow-electronics AT90LS4433 Manual do Utilizador Página 53