MAX5936/MAX5937
-48V Hot-Swap Controllers with V
IN
Step Immunity and No R
SENSE
4 _______________________________________________________________________________________
Note 1: All currents into pins are positive and all currents out of pins are negative. All voltages referenced to V
EE
, unless otherwise
specified.
Note 2: All limits are 100% tested at +25°C and +85°C. Limits at -40°C and -10°C are guaranteed by characterization.
Note 3: Delay time from a valid on-condition until the load probe test begins.
Note 4: V
EE
or UVLO voltages below V
UVLO,F
or V
UVLO_REF,F
, respectively, are ignored during this time.
Note 5: The time (V
OUT
- V
EE
) > V
SC
+ overdrive until (V
GATE
- V
EE
) drops to approximately 90% of its initial high value.
Note 6: The time when the PGOOD (PGOOD) condition is met until the PGOOD (PGOOD) signal is asserted.
ELECTRICAL CHARACTERISTICS (continued)
(V
EE
= -10V to -80V, V
IN
= GND - V
EE
, V
STEP_MON
=V
EE
, R
LP
= 200Ω, UVLO open, T
A
= -40°C to +85°C, unless otherwise noted.
Typical values are at V
EE
= -48V, T
A
= +25°C.) (Notes 1, 2)
Comentários a estes Manuais