Rainbow-electronics ATtiny861_V Manual do Utilizador Página 186

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 236
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 185
186
2588B–AVR–11/06
ATtiny261/461/861
Notes: 1. Typical values at 25 °C. Maximum values are characterized values and not test limits in production.
2. “Max” means the highest value where the pin is guaranteed to be read as low.
3. “Min” means the lowest value where the pin is guaranteed to be read as high.
4. Although each I/O port can sink more than the test conditions (10 mA at V
CC
= 5V, 5 mA at V
CC
= 3V) under steady state
conditions (non-transient), the following must be observed:
1] The sum of all IOL, for all ports, should not exceed 60 mA.
If IOL exceeds the test condition, VOL may exceed the related specification. Pins are not guaranteed to sink current greater
than the listed test condition.
5. Although each I/O port can source more than the test conditions (10 mA at V
CC
= 5V, 5 mA at V
CC
= 3V) under steady state
conditions (non-transient), the following must be observed:
1] The sum of all IOH, for all ports, should not exceed 60 mA.
If IOH exceeds the test condition, VOH may exceed the related specification. Pins are not guaranteed to source current
greater than the listed test condition.
6. Values using methods described in ”Minimizing Power Consumption” on page 35. Power Reduction is enabled (PRR =
0xFF) and there is no I/O drive.
7. BOD Disabled.
I
CC
Power Supply Current
Active 1MHz, V
CC
= 2V
(6)
0.4 0.6 mA
Active 4MHz, V
CC
= 3V
(6)
23mA
Active 8MHz, V
CC
= 5V
(6)
69mA
Idle 1MHz, V
CC
= 2V
(6)
0.1 0.3 mA
Idle 4MHz, V
CC
= 3V
(6)
0.4 1 mA
Idle 8MHz, V
CC
= 5V
(6)
1.5 3 mA
Power-down mode
WDT enabled, V
CC
= 3V
(7)
410µA
WDT disabled, V
CC
= 3V
(7)
0.15 2 µA
T
A
= -40°C to 85°C, V
CC
= 1.8V to 5.5V (unless otherwise noted)
(1)
(Continued)
Symbol Parameter Condition Min. Typ. Max. Units
Vista de página 185
1 2 ... 181 182 183 184 185 186 187 188 189 190 191 ... 235 236

Comentários a estes Manuais

Sem comentários