Rainbow-electronics ATtiny10 Manual do Utilizador descarregar pdf (Página 106)

106

8127B–AVR–08/09

ATtiny4/5/9/10

• Bits 2:0 – GT[2:0]: Guard Time

These bits specify the number of additional IDLE bits that are inserted to the idle time when

changing from reception mode to transmission mode. Additional delays are not inserted when

changing from transmission mode to reception.

The total idle time when changing from reception to transmission mode is Guard Time plus two

IDLE bits. Table 14-13 shows the available Guard Time settings.

The default Guard Time is 128 IDLE bits. To speed up the communication, the Guard Time

should be set to the shortest safe value.

14.7.3 TPISR – Tiny Programming Interface Status Register

• Bits 7:2, 0 – Res: Reserved Bits

These bits are reserved and will always read zero.

• Bit 1 – NVMEN: Non-Volatile Memory Programming Enabled

NVM programming is enabled when this bit is set. The external programmer can poll this bit to

verify the interface has been successfully enabled.

NVM programming is disabled by writing this bit to zero.

Table 14-13. Guard Time Settings

GT2 GT1 GT0 Guard Time (Number of IDLE bits)

0 0 0 +128 (default value)

001+64

010+32

011+16

100+8

101+4

110+2

111+0

Bit 76543210

CSS: 0x00

– – – – – –NVMEN–TPIPCR

Read/WriteRRRRRRR/WR

Initial Value00000000

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 165 166

Sem comentários

Rainbow-electronics ATtiny10 Manual do Utilizador Página 106