Rainbow-electronics ATR0635P1 Manual do Utilizador Página 9

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 35
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 8
9
4979D–GPS–06/08
ATR0635P1
3.2 Signal Description
VDD_USB
(3)
A10 Supply
VDD18 H9 Supply
VDD18 G11 Supply
VDD18 F12 Supply
VDD18 B9 Supply
VDD18 E5 Supply
VDDIO
(4)
B5 Supply
VDDIO H5 Supply
VDIG A5 Supply
X A2 Analog OUT
XT_IN A12 Analog IN
XT_OUT B12 Analog OUT
XTO A1 Analog Input
Table 3-2. Signal Description
Pin Number Pin Name Type Active Level Pin Description/Comment
RF Section
D1 RF ANALOG IN - Input from SAW filter
C1 NRF ANALOG IN - Inverted input from SAW filter
GPS XTAL Section
A1 XTO ANALOG IN - TCXO input (23.104 MHz)
B3 NXTO ANALOG IN - Inverted TCXO input (23.104 MHz)
A2 X ANALOG OUT - XTO interface (capacitor)
B2 NX ANALOG OUT - Inverted XTO interface (capacitor)
RTC Section
A12 XT_IN ANALOG IN - Oscillator input (32.768 kHz)
B12 XT_OUT ANALOG OUT - Oscillator output (32.768 kHz)
Automatic Gain Control, bandwidth setting
A4 AGCO ANALOG IO - Automatic gain control analog voltage, connect shunt capacitor to GND
D4 EGC DIGITAL IN -
Enable external gain control
(high = software gain control, low = automatic gain control)
G12 AGCOUT0 DIGITAL OUT - Software gain control
C4 SDI DIGITAL IN - Software gain control
Table 3-1. ATR0635P1 Pinout (Continued)
Pin Name BGA 96 Pin Type
Pull Resistor
(Reset Value)
(1)
Firmware Label
PIO Bank A
IO
Notes: 1. PD = internal pull-down resistor, PU = internal pull-up resistor, OH = switched to Output High at reset
2. VBAT18 represent the internal power supply of the backup power domain, see section “Power Supply” on page 20.
3. VDD_USB is the supply voltage for following the USB pins: USB_DM and USB_DP, see section “Power Supply” on page
20. For operation of the USB interface, supply of 3.0V to 3.6V is required.
4. VDDIO is the supply voltage for the following GPIO pins: P1, P2, P8, P12, P14, P16, P17, P18, P19, P20, P21, P23, P24,
P25, P26, P27 and P29, see section “Power Supply” on page 20.
Vista de página 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 34 35

Comentários a estes Manuais

Sem comentários