Rainbow-electronics ATmega162V Manual do Utilizador descarregar pdf (Página 262)

262

ATmega162/V

2513E–AVR–09/03

Reading the Fuses and Lock

Bits

1. Enter JTAG instruction PROG_COMMANDS.

2. Enable Fuse/Lock bit read using programming instruction 8a.

3. To read all Fuses and Lock bits, use programming instruction 8f.

To only read Fuse Extended byte, use programming instruction 8b.

To only read Fuse High byte, use programming instruction 8c.

To only read Fuse Low byte, use programming instruction 8d.

To only read Lock bits, use programming instruction 8e.

Reading the Signature Bytes 1. Enter JTAG instruction PROG_COMMANDS.

2. Enable Signature byte read using programming instruction 9a.

3. Load address 0x00 using programming instruction 9b.

4. Read first signature byte using programming instruction 9c.

5. Repeat steps 3 and 4 with address 0x01 and address 0x02 to read the second

and third signature bytes, respectively.

Reading the Calibration Byte 1. Enter JTAG instruction PROG_COMMANDS.

2. Enable Calibration byte read using programming instruction 10a.

3. Load address 0x00 using programming instruction 10b.

4. Read the calibration byte using programming instruction 10c.

1 2 ... 257 258 259 260 261 262 263 264 265 266 267 ... 322 323

Sem comentários

Rainbow-electronics ATmega162V Manual do Utilizador Página 262