Rainbow-electronics MAX1844 Manual do Utilizador Página 10

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 23
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 9
Detailed Description
The MAX1844 buck controller is targeted for low-voltage
power supplies for notebook computers. Maxims propri-
etary Quick-PWM pulse-width modulator in the MAX1844
is specifically designed for handling fast load steps while
maintaining a relatively constant operating frequency
and inductor operating point over a wide range of input
voltages. The Quick-PWM architecture circumvents the
poor load-transient timing problems of fixed-frequency
current-mode PWMs while also avoiding the problems
caused by widely varying switching frequencies in con-
ventional constant-on-time and constant-off-time PWM
schemes.
5V Bias Supply (V
CC
and V
DD
)
The MAX1844 requires an external 5V bias supply in
addition to the battery. Typically, this 5V bias supply is
the notebooks 95% efficient 5V system supply. Keeping
the bias supply external to the IC improves efficiency
and eliminates the cost associated with the 5V linear reg-
ulator that would otherwise be needed to supply the
PWM circuit and gate drivers. If stand-alone capability is
needed, the 5V supply can be generated with an exter-
nal linear regulator such as the MAX1615.
The battery and 5V bias inputs can be connected
together if the input source is a fixed 4.5V to 5.5V supply.
If the 5V bias supply is powered up prior to the
MAX1844
High-Speed Step-Down Controller with
Accurate Current Limit for Notebook Computers
10 ______________________________________________________________________________________
V
CC
UVP
V
IN
7V TO 20V
5V
BIAS SUPPLY
C2
330µF
SEE TABLE 1 FOR OTHER COMPONENT SELECTIONS.
POWER-GOOD
INDICATOR
L1
4.7µH
V
OUT
2.5V
SHDN
V+
D2
CMPSH-3
C6
3.3µF
C7
0.1µF
C4
0.22µF
270k
130k
Q1
D1
R2
100k
Q2
R
SENSE
15m
C5
4.7µF
R1
20
SKIP
ILIM
ON/OFF
CONTROL
LOW-NOISE
CONTROL
DL
LX
BST
DH
CS
OUT
FB
LATCH
OVP
PGOOD
V
DD
MAX1844
5V
TON
REF
GND
C1
10µF
Figure 1. Standard Application Circuit
Vista de página 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Comentários a estes Manuais

Sem comentários