Rainbow-electronics ATtiny26L Manual do Utilizador descarregar pdf (Página 108)

108

ATtiny26(L)

1477B–AVR–04/02

Latching of Fuses The fuse values are latched when the device enters programming mode and changes of

the fuse values will have no effect until the part leaves programming mode. This does

not apply to the EESAVE Fuse which will take effect once it is programmed. The fuses

are also latched on Power-up in normal mode.

Signature Bytes All Atmel microcontrollers have a three-byte signature code which identifies the device.

This code can be read in both serial and parallel mode, also when the device is locked.

The three bytes reside in a separate address space.

For the ATtiny26 the signature bytes are:

1. $000: $1E (indicates manufactured by Atmel).

2. $001: $91 (indicates 2KB Flash memory).

3. $002: $09 (indicates ATtiny26 device when $001 is $91).

Calibration Byte The ATtiny26 stores four different calibration values for the internal RC Oscillator. These

bytes resides in the signature row high byte of the addresses 0x0000, 0x0001, 0x0002,

and 0x0003 for 1, 2, 4, and 8 MHz respectively. During Reset, the 1 MHz value is auto-

matically loaded into the OSCCAL Register. If other frequencies are used, the

calibration value has to be loaded manually, see “Oscillator Calibration Register – OSC-

CAL” on page 31 for details.

Parallel Programming

Parameters, Pin

Mapping, and

Commands

This section describes how to parallel program and verify Flash Program memory,

EEPROM Data memory, Memory Lock bits, and Fuse bits in the ATtiny26. Pulses are

assumed to be at least 250 ns unless otherwise noted.

Signal Names In this section, some pins of the ATtiny26 are referenced by signal names describing

their functionality during parallel programming, see Figure 58 and Table 51. Pins not

described in the following table are referenced by pin names.

The XA1/XA0 pins determine the action executed when the XTAL1 pin is given a posi-

tive pulse. The bit coding is shown in Table 53.

When pulsing WR

or OE, the command loaded determines the action executed. The dif-

ferent Commands are shown in Table 54.

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 150 151

Sem comentários

Rainbow-electronics ATtiny26L Manual do Utilizador Página 108