MAX14514
Dual Electroluminescent Lamp Driver
_______________________________________________________________________________________ 3
ABSOLUTE MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS
(V
DD
= +2.7V to +5.5V, C
LAMP_TOTAL
= 10nF, C
CS
= 3.3nF, L
X
= 220µH (I
SAT
= 170mA, R
S
= 5.5Ω), T
A
= -40°C to +85°C, unless oth-
erwise noted. Typical values are at V
DD
= +3.0V, T
A
= +25°C.) (Note 2)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
Note 1: Package thermal resistances were obtained using the method described in JEDEC specification JESD51-7, using a four-layer
board. For detailed information on package thermal considerations, refer to www.maxim-ic.com/thermal-tutorial
.
(Voltages referenced to GND.)
V
DD
........................................................................-0.3V to +6.0V
CS, LX...................................................................-0.3V to +160V
V
1
, V
2
, COM................................................-0.3V to (V
CS
+ 0.3V)
SW, EL, DIM_, SLEW, CAP, EN ..................-0.3V to (V
DD
+ 0.3V)
Continuous Power Dissipation (T
A
= +70°C)
14-Pin TDFN (derate 24.4mW/°C above +70°C) .......1951mW
Junction-to-Case Thermal Resistance (θ
JC
) (Note 1)
14-Pin TDFN...................................................................8°C/W
Junction-to-Ambient Thermal Resistance (θ
JA
) (Note 1)
14-Pin TDFN.................................................................41°C/W
Operating Temperature Range ...........................-40°C to +85°C
Junction Temperature......................................................+150°C
Storage Temperature Range .............................-65°C to +150°C
Lead Temperature (soldering, 10s) .................................+300°C
Comentários a estes Manuais