Rainbow-electronics ATMOS™ 2M60 Manual do Utilizador

Main Features• High Sensitivity and High SNR Performance 2/3" CMOS Sensor • Total Resolution of 2.5M (with 5 µm Square Pixels)• High Data Rate:

105440A–IMAGE–10/05ATMOS -2M60/2M30 [Preliminary] 4.1.5 ITC ModePrinciple: An external sync controls both the integration time and the frame rate.

115440A–IMAGE–10/05[Preliminary] ATMOS -2M60/2M304.2 Ouput Data TimingFigure 4-6. Output Data Chronogram5. Camera Features5.1 Region of InterestThe f

125440A–IMAGE–10/05ATMOS -2M60/2M30 [Preliminary] 5.3 Output FormatThe data format available on the Camera Link output interface is programmable vi

135440A–IMAGE–10/05[Preliminary] ATMOS -2M60/2M305.6 Look- up Table (LUT)The look-up Table is a conversion table which applies to the sensor data. At

145440A–IMAGE–10/05ATMOS -2M60/2M30 [Preliminary] 5.10 Digital Processing SynopticFigure 5-2. Synoptic5.11 Defective Pixels CorrectionThe sensor ma

155440A–IMAGE–10/05[Preliminary] ATMOS -2M60/2M306. Electrical Interface6.1 Power SupplyIt is recommended to insert a 1A fuse between the power suppl

165440A–IMAGE–10/05ATMOS -2M60/2M30 [Preliminary] 6.4 Serial CommunicationThe Camera Link interface provides two LVDS signal pairs for the communic

175440A–IMAGE–10/05[Preliminary] ATMOS -2M60/2M3010A 1 RW - 0Current configuration restore from Eeprom1 to 4: User settings10B 1 WO -FPN coefficient

185440A–IMAGE–10/05ATMOS -2M60/2M30 [Preliminary] Note: RO: Read Only register, WO: Write Only register, RW: Read and Write register.240 2 RW - 0Se

195440A–IMAGE–10/05[Preliminary] ATMOS -2M60/2M306.4.2 Camera Settings MemoryATMOS cameras have 5 banks to save settings:• Bank 0 contains the factor

25440A–IMAGE–10/05ATMOS -2M60/2M30 [Preliminary] 1. Typical Performances Note: 1. Measured with light source 3200°K and BG38 IR cut-off filter 2 mm

205440A–IMAGE–10/05ATMOS -2M60/2M30 [Preliminary] 7.2 Camera Link ConnectorStandard Camera Link cable shall be used to ensure the full electrical c

215440A–IMAGE–10/05[Preliminary] ATMOS -2M60/2M308. Mechanical DrawingNote: (All dimensions are in mm)Figure 8-1. Front Panel View Figure 8-2. Front

225440A–IMAGE–10/05ATMOS -2M60/2M30 [Preliminary] Figure 8-3. Rear PanelFigure 8-4. Rear Panel Mechanical Drawing31.30 23 9.90 22.80 4412-24VTTL I

235440A–IMAGE–10/05[Preliminary] ATMOS -2M60/2M309. Ordering CodeDelivery: ATMOS areascan cameras are delivered with:• Power supply female connector

Printed on recycled paper.5440A–IMAGE–10/05© Atmel Corporation 2005. All rights reserved. Atmel®, logo and combinations thereof, and Everywhere You A

35440A–IMAGE–10/05[Preliminary] ATMOS -2M60/2M30Figure 1-1. Responsivity DiagramFigure 1-2. Quantum EfficiencyResponsivity at 0 dB gain0%20%40%60%80%

45440A–IMAGE–10/05ATMOS -2M60/2M30 [Preliminary] 2. Standard ConformityThe cameras have been tested in the following conditions:• Camera with compl

55440A–IMAGE–10/05[Preliminary] ATMOS -2M60/2M303. Camera DescriptionFigure 3-1. Camera SynopticThe camera is based on a single tap CMOS sensor which

65440A–IMAGE–10/05ATMOS -2M60/2M30 [Preliminary] 4. Timing 4.1 Synchronization ModesThe camera operates in rolling shutter mode. 4.1.1 Optimal Use

75440A–IMAGE–10/05[Preliminary] ATMOS -2M60/2M30If shutter time is set to > 0:Readout is suspended between two consecutive frame readout and shutt

85440A–IMAGE–10/05ATMOS -2M60/2M30 [Preliminary] • Readout of frame N. The readout data is forwarded to the Camera Link interface (FVAL active) sta

95440A–IMAGE–10/05[Preliminary] ATMOS -2M60/2M30• Readout of frame N. The readout data is forwarded to the Camera Link interface (FVAL active) starti