
MAX6657/MAX6658/MAX6659
_______________________________________________________________________________________ 5
PIN
MAX6657
MAX6658
MAX6659
NAME FUNCTION
11V
CC
Supply Voltage Input, +3V to +5.5V. Bypass to GND with a 0.1µF capacitor. A 200Ω
series resistor is recommended but not required for additional noise filtering. See
Typical Operating Circuit.
2 3 DXP
Combined Remote-Diode Current Source and A/D Positive Input for Remote-Diode
Channel. DO NOT LEAVE DXP FLOATING; connect DXP to DXN if no remote diode
is used. Place a 2200pF capacitor between DXP and DXN for noise filtering.
3 4 DXN
Combined Remote-Diode Current Sink and A/D Negative Input. DXN is internally
biased to one diode drop above ground.
46OVERT1
Overtemperature Active-Low Output, Open-Drain. Output is logic low only when
temperature is above the software programmed threshold.
5 7, 8 GND Ground
69ALERT
SMBus Alert (Interrupt) Active-Low Output, Open-Drain. Asserts when temperature
exceeds user-set limits (high or low temperature). Stays asserted until acknowledged
by either reading the Status register or by successfully responding to an Alert
Response address. See
ALERT
Interrupts.
7 12 SMBDATA SMBus Serial-Data Input/Output, Open-Drain
8 14 SMBCLK SMBus Serial-Clock Input
— 5 ADD
SMBus Address-Select Pin. The MAX6659 is set to one of three available addresses
(connect to V
CC
, GND, or leave open). See Slave Addresses section.
—10OVERT2
Overtemperature Active-Low Output, Open-Drain. Output is logic low only when
temperature is above the software programmed threshold.
—15STBY
Hardware Standby Input. Temperature and comparison threshold data are retained in
standby mode. If STBY is low, the IC is put into standby mode.
— 2, 11, 13, 16 N.C. Not internally connected. Do not make connections to these pins.
Pin Description
±1°C, SMBus-Compatible Remote/Local Temperature
Sensors with Overtemperature Alarms
Comentários a estes Manuais