Rainbow-electronics MAX1715 Manual do Utilizador Página 5

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 25
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 4
MAX1715
Ultra-High Efficiency, Dual Step-Down
Controller for Notebook Computers
_______________________________________________________________________________________ 5
60
0.01 1010.1
90
100
80
70
MAX1715-01
LOAD CURRENT (A)
EFFICIENCY (%)
EFFICIENCY vs. LOAD CURRENT
(1.8V, 4A COMPONENTS, SKIP = GND)
V+ = +7V
V+ = +12V
V+ = +20V
0
0.01 1010.1
60
80
100
40
20
MAX1715-02
LOAD CURRENT (A)
EFFICIENCY (%)
EFFICIENCY vs. LOAD CURRENT
(1.8V, 4A COMPONENTS, SKIP = V
CC
)
V+ = +7V
V+ = +20V
V+ = +12V
60
0.01 1010.1
90
100
80
70
MAX1715-03
LOAD CURRENT (A)
EFFICIENCY (%)
EFFICIENCY vs. LOAD CURRENT
(2.5V, 4A COMPONENTS, SKIP = GND)
V+ = +7V
V+ = +20V
V+ = +12V
Note 1: Specifications to -40°C are guaranteed by design, and not production tested.
Note 2: When the inductor is in continuous conduction, the output voltage will have a DC regulation higher than the trip level by
50% of the ripple. In discontinuous conduction (SKIP = AGND, light load) the output voltage will have DC regulation
higher than the trip level by approximately 1.5% due to slope compensation.
Note 3: On-time and off-time specifications are measured from the 50% point at the DH pin with LX = PGND, V
BST
= 5V. Actual
in-circuit times may differ due to MOSFET switching speeds.
__________________________________________Typical Operating Characteristics
(Circuit of Figure 1, components from Table 1, V
IN
= +15V, SKIP = AGND, TON = unconnected, T
A
= +25°C, unless otherwise noted.)
ELECTRICAL CHARACTERISTICS (continued)
(Circuit of Figure 1, 4A components from Table 1, V
CC =
V
DD
= +5V, SKIP = AGND, V+ = 15V, T
A
= -40°C to +85°C, unless otherwise
noted.) (Note 1)
Quiescent Battery Current (V+) 25 70 µA
Reference Voltage 1.97 2 2.03 VNo external REF load
Quiescent Supply Current
(V
CC
+ V
DD
)
1100 1600 µAFB1 and FB2 forced above the regulation point
PARAMETER MIN TYP MAX UNITSCONDITIONS
Reference Load Regulation 0.01 VI
REF
= 0 to 50µA
Overvoltage Trip Threshold 10 12.5 15 %With respect to error comparator threshold
Output Undervoltage Threshold 60 70 80 %With respect to error comparator threshold
Current-Limit Threshold (positive
direction, fixed)
75 100 125 mVPGND - LX_, I
LIM
= V
CC
Current-Limit Threshold (positive
direction, adjusted)
32 50 62
mV
PGND - LX_, I
LIM
resistor = 100k
PGND - LX_, I
LIM
resistor = 400k 160 200 240
Thermal Shutdown Threshold 150 °CHysteresis = 10°C
Rising edge, hysteresis = 20mV, PWM disabled below
this level
4.1 4.4 V
V
CC
Undervoltage Lockout
Threshold
Logic Input High Voltage 2.4 V
ON_, SKIP
ON_, SKIP
0.8 VLogic Input Low Voltage
SKIP, to deactivate OVP circuitry
-5 -1 mALogic Input Current
Vista de página 4
1 2 3 4 5 6 7 8 9 10 ... 24 25

Comentários a estes Manuais

Sem comentários