Rainbow-electronics AT89C55WD Manual do Utilizador descarregar pdf (Página 22)

AT89C55WD

1921B–MICRO–09/02

puts,andthenextcyclemaybegin.DataPolling may begin any time after a write cycle has

been initiated.

Ready/Busy

: The progress of byte programming can also be monitored by the RDY/BSY out-

put signal. P3.0 is pulled low after ALE goes high during programming to indicate BUSY

.P3.0

is pulled high again when programming is done to indicate READY.

Program Verify: If lock bits LB1 and LB2 have not been programmed, the programmed code

data can be read back via the address and data lines for verification. The status of the individ-

ual lock bits can be directly verified by reading them back.

Reading the Signature Bytes: The signature bytes are read by the same procedure as a nor-

mal verification of locations 000H, 100H, and 200H, except that P3.6 and P3.7 must be pulled

to a logic low. The values returned are as follows:

(000H) = 1EH indicates manufactured by Atmel

(100H) = 55H

(200H) = 06H indicates 89C55WD

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 36 37

Sem comentários

Rainbow-electronics AT89C55WD Manual do Utilizador Página 22