Rainbow-electronics MAX513 Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Satélite Rainbow-electronics MAX513. Rainbow Electronics MAX513 User Manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 16
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
_______________General Description
The MAX512/MAX513 contain three 8-bit, voltage-output
digital-to-analog converters (DAC A, DAC B, and DAC C).
Output buffer amplifiers for DACs A and B provide voltage
outputs while reducing external component count. The
output buffer for DAC A can source or sink 5mA to within
0.5V of V
DD
or V
SS
. The buffer for DAC B can source or
sink 0.5mA to within 0.5V of V
DD
or V
SS
. DAC C is
unbuffered, providing a third voltage output with increased
accuracy. The MAX512 operates with a single
+5V ±10% supply, and the MAX513 operates with a
+2.7V to +3.6V supply. Both devices can also operate
with split supplies.
The 3-wire serial interface has a maximum operating fre-
quency of 5MHz and is compatible with SPI™, QSPI™,
and Microwire™. The serial input shift register is 16 bits
long and consists of 8 bits of DAC input data and 8 bits
for DAC selection and shutdown. DAC registers can be
loaded independently or in parallel at the positive edge
of
C
S
. A latched logic output is also available for auxil-
iary control.
Ultra-low power consumption and small packages
(14-pin DIP/SO) make the MAX512/MAX513 ideal for
portable and battery-powered applications. Supply cur-
rent is only 1mA, dropping to less than 1µA in shutdown.
Any of the three DACs can be independently shut down.
In shutdown mode, the DAC's R-2R ladder network is
disconnected from the reference input, minimizing sys-
tem power consumption.
________________________Applications
Digital Gain and Offset Adjustment
Programmable Attenuators
Programmable Current Sources
Programmable Voltage Sources
RF Digitally Adjustable Bias Circuits
VCO Tuning
____________________________Features
Operate from a Single +5V (MAX512) or
+3V (MAX513) Supply, or from Bipolar Supplies
Low Power Consumption
1mA Operating Current
<1µA Shutdown Current
Unipolar or Bipolar Outputs
5MHz, 3-Wire Serial Interface
SPI, QSPI, and Microwire Compatible
Two Buffered, Bipolar-Output DACs (DACs A/B)
Independently Programmable Shutdown Mode
Space-Saving 14-Pin SO/DIP Packages
Pin and Software Reset
______________Ordering Information
Ordering Information continued at end of data sheet.
* Contact factory for dice specifications.
MAX512/MAX513
Low-Cost, Triple, 8-Bit Voltage-Output DACs
with Serial Interface
________________________________________________________________
Maxim Integrated Products
1
DAC
LATCH
A
DAC A
DAC
LATCH
B
DAC B
DAC
LATCH
C
LATCH
DAC C
SCLK
OUTA
OUTB
OUTC
LOUT
DIN CS REFAB REFC
RESET
V
DD
V
SS
GND
16-BIT SHIFT REGISTER
CONTROL (8) DATA (8)
MAX512
MAX513
12
4
567
8
9
10
1112
14
3
________________Functional Diagram
1
2
3
4
14
13
12
11
LOUT
I.C.
REFAB
REFC
RESET
SCLK
CS
DIN
DIP/SO
TOP VIEW
MAX512
MAX513
5
6
7
10
9
8
OUTC
OUTB
OUTA
V
SS
GND
V
DD
__________________Pin Configuration
19-0252; Rev 2; 5/96
PART TEMP. RANGE PIN-PACKAGE
MAX512CPD
0°C to +70°C 14 Plastic DIP
MAX512CSD 0°C to +70°C 14 SO
MAX512C/D 0°C to +70°C Dice*
Microwire is a trademark of National Semiconductor Corp. SPI and QSPI are trademarks of Motorola Inc.
For free samples & the latest literature: http://www.maxim-ic.com, or phone 1-800-998-8800
Vista de página 0
1 2 3 4 5 6 ... 15 16

Resumo do Conteúdo

Página 1 - MAX512/MAX513

_______________General DescriptionThe MAX512/MAX513 contain three 8-bit, voltage-outputdigital-to-analog converters (DAC A, DAC B, and DAC C).Output b

Página 2

SDINSCLKCSQ2 Q1 SC SB SA LC LB LA D7 D6 D5 D4 D3 D2 D1 D0OPTIONALINSTRUCTIONEXECUTED(CONTROL BYTE) (DATA BYTE)Figure 2. MAX512/MAX513 3-Wire Serial-I

Página 3

MAX512/MAX513Low-Cost, Triple, 8-Bit Voltage-Output DACs with Serial Interface________________________________________________________________________

Página 4

MAX512/MAX513Low-Cost, Triple, 8-Bit Voltage-Output DACs with Serial Interface12 _____________________________________________________________________

Página 5

Bipolar OutputUsing Figure 4’s circuit, the MAX512/MAX13 can be con-figured for bipolar outputs. Table 4 lists the bipolar codesand corresponding outp

Página 6

MAX512/MAX513Low-Cost, Triple, 8-Bit Voltage-Output DACs with Serial Interface14 _____________________________________________________________________

Página 7

MAX512/MAX513Low-Cost, Triple, 8-Bit Voltage-Output DACs with Serial Interface________________________________________________________________________

Página 8

Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses arei

Página 9

LSBMAX512/MAX513Low-Cost, Triple, 8-Bit Voltage-Output DACs with Serial Interface2 ___________________________________________________________________

Página 10

MAX512/MAX513Low-Cost, Triple, 8-Bit Voltage-Output DACs with Serial Interface________________________________________________________________________

Página 11

MAX512/MAX513Low-Cost, Triple, 8-Bit Voltage Output DACs with Serial Interface4 ______________________________________________________________________

Página 12

MAX512/MAX513Low-Cost, Triple, 8-Bit Voltage Output DACs with Serial Interface________________________________________________________________________

Página 13

CLOCK FEEDTHROUGH (OUTA)B 1µs/divA A: SCLK, 333kHz, 0V TO 2.9V, 2V/divB: OUTA, 2mV/divVSS = 0V, CS = HIGHCLOCK FEEDTHROUGH (OUTC)B 1µs/divA

Página 14

MAX512/MAX513Low-Cost, Triple, 8-Bit Voltage Output DACs with Serial Interface________________________________________________________________________

Página 15

MAX512/MAX513Low-Cost, Triple, 8-Bit Voltage-Output DACs with Serial Interface8 ______________________________________________________________________

Página 16

MAX512/MAX513Low-Cost, Triple, 8-Bit Voltage-Output DACs with Serial Interface________________________________________________________________________

Comentários a estes Manuais

Sem comentários