Rainbow-electronics GM862-QUAD-PY Manual do Utilizador descarregar pdf (Página 61)

AT Commands Reference Guide

80000ST10025a Rev. 5 - 09/07/08

S2 - Escape Character SELINT 2

ATS2=[<char>]

Set command sets the ASCII character to be used as escape character.

Parameter:

<char> - escape character decimal ASCII

0..255 - factory default value is 43 (+).

Note: the escape sequence consists of three escape characters preceded

and followed by n ms of idle (see S12 to set n).

ATS2?

Read command returns the current value of S2 parameter.

Note: the format of the numbers in output is always 3 digits, left-filled with 0s

3.5.3.7.4 Command Line Termination Character - S3

S3 - Command Line Termination Character SELINT 0 / 1

ATS3[=<char>]

Set command sets the value of the character either recognized by the

device as command line terminator and generated by the device as part of

the header, trailer, and terminator for result codes and information text,

along with S4 parameter.

Parameter:

<char> - command line termination character (decimal ASCII)

0..127 - factory default value is 13 (ASCII CR)

Note: the “previous” value of S3 is used to determine the command line

termination character for entering the command line containing the S3

setting command. However the result code issued shall use the “new” value

of S3 (as set during the processing of the command line).

ATS3?

Read command returns the current value of S3 parameter.

ATS3=?

Test command returns the range for <char> without command echo and

parenthesis.

Note For either Read and Test command the format of the numbers in output is

always 3 digits, left-filled with 0s

Reference V25ter

S3 - Command Line Termination Character SELINT 2

ATS3=[<char>]

Set command sets the value of the character either recognized by the

device as command line terminator and generated by the device as part of

the header, trailer, and terminator for result codes and information text,

along with S4 parameter.

Parameter:

<char> - command line termination character (decimal ASCII)

0..127 - factory default value is 13 (ASCII <CR>)

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 433 434

Comentários a estes Manuais

Sem comentários

Rainbow-electronics GM862-QUAD-PY Manual do Utilizador Página 61

Comentários a estes Manuais

Manuais e produtos relacionados com Recetor GPRS Rainbow-electronics GM862-QUAD-PY