Rainbow-electronics ATmega128L Manual do Utilizador descarregar pdf (Página 300)

100

101

300

ATmega128(L)

2467B–09/01

When the contents of the register is equal to the programming enable signature, pro-

gramming via the JTAG port is enabled. The register is reset to 0 on power-on reset,

and should always be reset when leaving programming mode.

Figure 147. Programming Enable Register

Programming Command

The Programming Command register is a 15-bit register. This register is used to serially

shift in programming commands, and to serially shift out the result of the previous com-

mand, if any. The JTAG Programming Instruction Set is shown in

Table 132. The state

sequence when shifting in the programming commands is illustrated in

Figure 149.

TDI

TDO

ClockDR & PROG_ENABLE

Programming enable

$A370

1 2 ... 295 296 297 298 299 300 301 302 303 304 305 ... 330 331

Comentários a estes Manuais

Sem comentários

Rainbow-electronics ATmega128L Manual do Utilizador Página 300

Comentários a estes Manuais

Manuais e produtos relacionados com Sensores Rainbow-electronics ATmega128L